BBC micro:bit Go Bundle
This micro:bit Go Bundle provides you with everything you need to get hooked up and powered. This kit includes the micro:bit, a short USB cable, a AAA battery holder and AAA batteries. Also inside the Go Bundle you will find a Quick Start Guide with four unique ideas to get you started with micro:bit! The Go Bundle is a quick and economical way to get started with the micro:bit.
On the front of the board you will find the 5x5 LED array, which you can use as a light sensor; a tiny screen to draw on or display words, numbers and other information; and the two programmable buttons! On the back of the board you will find the brains of the micro:bit, a 16MHz, 32-bit ARM Cortex-M0 microcontroller with 256KB Flash, 16KB RAM and a built-in temperature sensor. Additionally, the back of the micro:bit is populated by an accelerometer, compass and Bluetooth Smart antenna, as well as a microUSB and two-pin JST connector for different power options. Finally, at the bottom of the board you will find 20 gold-tabbed edge pins and five ring connectors (three for digital/analog I/O, two for power and ground) for hooking up external components. The tabs with larger holes can be easily used with alligator clips to prototype added components quickly.
The micro:bit has even supplied an intuitive mobile app that lets you send your code to your micro:bit over Bluetooth (without using a USB cable). With this app you will be able to interact with your micro:bit on a higher level of accessibility.
- 1x micro:bit Board
- 1x micro USB Cable --- 6in
- 1x Battery Holder --- 2xAAA
- 2x AAA Batteries
- 32-bit ARM Cortex-M0 CPU
- 256KB Flash
- 16KB RAM
- 5x5 Red LED Array
- Two Programmable Buttons
- Onboard Light, Compass, Accelerometer and Temp Sensors
- BLE Smart Antenna
- Three Digital/Analog Input/Output Rings
- Two Power Rings --- 3V and GND
- 20-pin Edge Connector
- MicroUSB Connector
- JST-PH Battery Connector (Not JST-XH)
- Reset Button with Status LED