L298N Motor Driver Board (2A)

The board can be used to drive either a single stepper motor, 2 bi-directional DC Motors, or 2 relays. Each channel is capable of 3A peak current, 2A continuous current, and if that is not enough the 2 channels can be paralleled to give you a single channel with a peak current of 6A, 4A continuous.

When using this board with input voltages higher than 12V DC, remove the jumper to disable the onboard 5V Regulator and apply a 5V source to the screw terminal labeled “5V”. With input voltages 24V and higher we also recommend removing the 35V rated capacitor just above it.

Features:

• Main Control Chip: L298N
• Logic Voltage: 5V
• Logic Current: 0mA-36mA
• Driving Voltage: 5V-35V
• Drive Current: 2A (maximum single bridge)
• Storage Temperature: -20 ° C~+135 ° C
• Maximum Power: 25W
• Size: 43 x 43 x 27mm