Vibration Sensor Module (SW-420)

The Vibration module based on the vibration sensor SW-420 and Comparator LM393 to detect if there is any vibration that beyond the threshold. The threshold can be adjusted by the on-board potentiometer. When this no vibration, this module output logic LOW the signal indicate LED light, and vice versa.

Principle

Usually at any angle switch is ON state, by the vibration or movement, the rollers of the conduction current in the switch will produce a movement or vibration, causing the current through the disconnect or the rise of the resistance and trigger circuit. The characteristics of this switch is usually general in the conduction state briefly disconnected resistant to vibration, so it's high sensitivity settings by IC, customers according to their sensitivity requirements for adjustments.

Application Ideas

• Vibration detecting
• Burglary protection system
• Object Movement detecting
• Triggering effect reported theft alarm
• Smart car
• Earthquake alarm
• Motorcycle alarm

Features

• The default state of the switch is close
• Digital output Supply voltage:3.3V-5V
• On-board indicator LED to show the results
• On-board LM393 chip
• SW-420 based sensor, normally closed type vibration sensor
• Dimension of the board: 3.2cm x 1.4cm