MQ-135 Air Quality Sensor

Product Code: 0745
Availability: In Stock
$7.99CAD

10 or more $7.59CAD
100 or more $7.19CAD
     0 reviews  |  Write a review

The MQ-135 air quality sensor is extremely sensitive to ammonia, sulfide, bernze, smoke, and other harmful gas. The resistance of the sensitive component changes as the concentration of the gas changes making it ideal for air quality control applications. The tested concentration range from 10 to 1000ppm.

Features:

  • Using a simple circuit can change the conductivity Conversion of an output signal corresponding to the gas concentration
  • Sensitive material MQ135 gas sensor is used in clean air low conductivity tin oxide (SnO2). When the sensor is kept in their environment In the polluting gases, the conductivity sensor with increasing air pollution in gas concentration increases
  • MQ135 sensor for ammonia, sulfide, benzene vapor high sensitivity of the smoke and other harmful monitor is also very good. This sensor can be seized measure a variety of harmful gases, is a low-cost sensors for a variety of applications

Specification:

  • It adopts high quality double panel design with power indication and TTL signal output indication
  • It has DO switch signal (TTL) output and AO analog signal output
  • The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
  • The voltage of the analog output, the higher the concentration, the higher the voltage
  • It has good sensitivity to gas and natural gas detection
  • There are four screw holes for easy positioning
  • Has a long service life and reliable stability
  • Fast response recovery characteristics

Technical Details:

  • Detection of Gas: Ammonia/Sulfide/Benzene vapor
  • Detection of Concentration: 10-1000ppm
  • Input Voltage: DC5V
  • Power Consumption (current): 150mA
  • DO Output: TTL digital quantities 0 and 1 (0.1 and 5V)
  • AO Output: 0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V
  • Using the Chip: AT89S52
  • Crystal: 11.0592MHZ
  • Baud Rate: 9600

Note: After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal.

We also carry:

Write a review

Note: HTML is not translated!